![]() Unfortunately, things did not seem to go smoothly for me. If your network card does not come with a packet driver ready, another method is to convert its ODI/NDIS driver to a compatible packet driver, known as shimming. Now it’s time to run DOS Internet apps (wget, minuet, doslynx, etc) to surf the web the vintage way! If everything is fine, you will see the card MAC address, reported under “My Ethernet address” after executing the above command. Without this, it will default to the AUI port, and will report a connection error unless you have the card connected to an AUI router. ![]() 1 (the last parameter) tells the packet driver to use the RJ45 port.0x2e0 is the base address of the card – this should again match the jumper settings.3 is the IRQ settings of the card (which should be a free IRQ and match the card jumper settings on the card ). ![]() 0圆0 is the address of the packet driver, which should be left as default,.After that, take note of the jumper settings on the card and execute the following command: 0圆0 3 0x2e0 1 The first step is to install a packet driver for the card under MS-DOS 6.22, available from crynwr. With some free time during the weekend and being a bit nostalgic, I pulled out a bunch of old ISA network cards from my junk box, planning to get my vintage 80386 computer on the Internet. After a visual check of the cards’ physical condition, I selected the 3COM Etherlink 16 (3C503-TP) card from the lot and use it for my experiment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |